Welcome to DTCTRUCK.COM ! Wrap new offers / gift every single day on Weekends – New Coupon code: DTCTRUCK2023
DTC-TRUCK-COM
track you order
Hotline +51900076559

My Cart -

$0.00
0
There are 0 item(s) in your cart
Subtotal: $0.00

Allison 1000 & 2000 Gen 4 Fault Codes: P0703 Brake Switch Circuit Malfunction – GMT 800 Only

Description

Allison 1000 & 2000 Gen 4 Fault Codes: P0703 Brake Switch Circuit Malfunction – GMT 800 Only

CIRCUIT DESCRIPTION:
A mechanical switch attached to the brake pedal sends a signal to the Transmission Control Module (TCM) indicating the service brake has been applied. This signal is either ignition voltage or a ground signal depending on the calibration installed in the TCM.

P0703 is a type C DTC.

CONDITIONS FOR RUNNING THE DTC:
1. The components are powered and ignition voltage is greater than 9V and less than 18V (12V TCM).
2. No DTC P0721 or P0722.

CONDITIONS FOR SETTING THE DTC:
The TCM sets a DTC when either of the following conditions occur:
1. The vehicle has accelerated 10 or more times with TCM input indicating brakes applied.
2. Decelerated 1 O or more times with TCM input indicating brakes released.

ACTION TAKEN WHEN THE DTC SETS:
1. No Grade Braking allowed.
2. Use the default assumption that the brake is off.
3. TCM inhibits TCC engagement.

CONDITIONS FOR CLEARING THE DTC/CHECK TRANS LIGHT:
A Scan Tool can clear the code from the TCM history. The TCM automatically clears the DTC from the TCM history if the vehicle completes 40 warm-up cycles without the DTC active.

DIAGNOSTIC AIDS:
Inspect the wiring for poor electrical connections at the TCM. Look for the following conditions:
1. A bent terminal.
2. A backed-out.
3. A damaged terminal.
4. Poor terminal tension.
5. A chafed wire.
6. A broken wire inside the insulation.

When diagnosing for an intermittent short or open, massage the wiring harness while watching the test equipment for a change.

Tags: ,

Reviews

There are no reviews yet.

Be the first to review “Allison 1000 & 2000 Gen 4 Fault Codes: P0703 Brake Switch Circuit Malfunction – GMT 800 Only”

Your email address will not be published. Required fields are marked *

x